Navigation

  • Fave 0

Doepfer A-112 Sampler Wavetable Vintage Edition

Doepfer A-112 Sampler Wavetable Vintage Edition | Rage Audio

Fabricante

Doepfer

StockEntrega en 5-7 días

166 €
O
100% Garantía oficial española del fabricante
Todos nuestro productos tienen garantia oficial en España
Empresa 100% española
Empresa localizada en España con local y tienda física

Comparte este producto

Sampler / Wavetable Module Vintage Edtion

Module A-112 is the combination of a voltage controlled 8 Bit Sampler and a wavetable oscillator. On top of it the module is able to generate...

Más información

Sampler / Wavetable Module Vintage Edtion


Module A-112 is the combination of a voltage controlled 8 Bit Sampler and a wavetable oscillator. On top of it the module is able to generate some special effects. 
A-112 was designed as an additional sound source with the typical sounds of the early 8 bit samplers and is not comparable with the modern polyphonic MIDI samplers available on the market. 


Sampling mode: 
- 8 bit audio resolution, 
- 128kB memory in 2 banks 64kB each (equivalent to 2 seconds of sampling time for each bank with 32 kHz sampling rate), 
- audio input with attenuator, 
- overload display in record mode (gate LED), 
- possibility of MIDI Dump to store sounds in a computer via MIDI, 
- non volatile memory for the 2 samples in the module, 
- manual tune control for adjustment of sampling rate for record and play,
- CV input (~ 1V/Oct), 
- both manual tune and CV determine the sampling rate respectively the pitch (pitch range is 5 octaves), 
- gate input (not a trigger: the sample starts at the positive edge of the gate signal and is played as long as gate is high or until the end of the sample is reached), 
- manual Gate button, 
- non filtered audio output (thus quantizing noise can be used as an element of the sound intentionally) 


Wavetable mode: 
- special appearance of the sampling mode when playing a sample, 
- the audio input is now used as a second control voltage input for moving through the sample in 256 byte wide loops (wavetables). 
- To achieve the typical wavetable oscillator sounds the sampling memory must contain corresponding wavetable data (normally loaded via MIDI dump). These data contain a set of wavetables with different harmonic content (e.g. a filter sweep) to get the typical wavetable sound while moving through the tables via CV2. But you may also use a "normal" sample and go through the sample with CV2 to obtain partially amazing sounds never heard before. 
- You may use for example sampled speech and go with CV2 through the syllables or speech shreds to get really very extreme sounds. 
- An ideal addition for this feature is the Offset/Attentuator module A-183-2 which can be used to adjust the position of the wavetable (Offset) and the modulation depth (Att.). 
- As modulation source an LFO (A-145, A-146, A-147, A-143-3), ADSR (A-140, A-141, A-142, A-143-1/2) or a random voltage (A-118, A-149-1) may be used. Even a ribbon controller (A-198 or R2M), the Theremin module A-178, the Joystick A-174 or the Wheels module A-174-2 are useful to drive through the wavetables.

Características

· Combinación de un sampler de 8 bits controlado por voltaje y un oscilador de tabla de ondas
· Panel frontal negro
· Anchura: 10HP / 50,5mm
· Profundidad: 100mm