Navigation

  • Fave 0

Doepfer A-198 Ribbon Controller + Manual

Doepfer A-198 Ribbon Controller + Manual | Rage Audio

  • Module Doepfer A-198 Ribbon Controller + Manual | Rage Audio
  • Side Doepfer A-198 Ribbon Controller + Manual | Rage Audio

Fabricante

Doepfer

StockEntrega en 5-7 días

252 €
O
100% Garantía oficial española del fabricante
Todos nuestro productos tienen garantia oficial en España
Empresa 100% española
Empresa localizada en España con local y tienda física

Comparte este producto

Doepfer A-198 Trautonium Manual / Ribbon Controller + Manual

Module A-198 is a Trautonium Manual resp. Ribbon Controller. The controlling element of the A-198 is a linear position sensor (length about 50 cm)...

Más información

Doepfer A-198 Trautonium Manual / Ribbon Controller + Manual

Module A-198 is a Trautonium Manual resp. Ribbon Controller. The controlling element of the A-198 is a linear position sensor (length about 50 cm) hat has available a pressure sensor too. 

Touching the sensor with a finger generates a control voltage CV1 that is proportional to the position of the finger. 
The scale (i.e. the relation between position difference and voltage difference) is adjustable with a potentiometer at the front panel. 

A hold switch is used to determine if the CV voltage is held after removing the finger (hold = on) or if the CV voltage jumps to 0V (hold = off). 
In the last case (hold = off) a gate signal is derived from the CV voltage whenever a finger touches the sensor (e.g. for triggering an envelope generator). 
A sensitive pressure sensor located below the position sensor generates a second control voltage CV2 that increases with higher pressure of the finger. 

Even for CV2 the scale is adjustable. 
A second gate signal is triggered as soon as the pressure exceeds a certain value. The gate threshold is adjustable at the front panel. 
The sensors are located in a separate metal frame (length about 600 mm, width about 30 mm, height about 18 mm, weight: about 900 g, color: silver-grey). 
The connection between the module and the sensor frame is made by a 4 pin cable (same as used for USB connections). 

Typical applications: 

- Trautonium manual, the string is replaced by the position sensor that is much easier to use and cheaper than the string. In combination with the Subharmonic Oscillator A-113, the Trautonium Filter A-104 and some auxiliary modules a complete Trautonium replica may be realized. In combination with the Quantizer A-156 exact semitone intervals are possible. 

- Ribbon Controller for any A-100 parameter (e.g. pitch, filter frequency, loudness, panorama, speed, modulation depth and so on) 

Características

Controlador de cinta:
· Genera control de voltaje CV1 (al tocar el sensor con el dedo)
· Segundo control de voltaje CV2 que puede generarse mediante sensor de presión incorporado
· Dimensiones: 600 x 30 x 30mm aprox. (con tapa de protección en el extremo derecho)

Módulo A-198:
· Para integrar el controlador de cinta Doepfer en un sistema modular A-100
· Genera control de voltaje para los osciladores
· Contiene 2 subunidades: Posición y Presión
· Formato Eurorack
· Anchura: 8HP
· Profundidad: 40mm
· Consumo de corriente: +40mA (+12V) / +20mA (+12V)