Navigation

  • Fave 0

Triton Audio PHANTOM BLOCKER

Triton Audio PHANTOM BLOCKER | Rage Audio

Fabricante

Triton Audio

StockEnvío inmediato

41 €
O
100% Garantía oficial española del fabricante
Todos nuestro productos tienen garantia oficial en España
Empresa 100% española
Empresa localizada en España con local y tienda física

Comparte este producto

Bloqueador de alimentación Phantom

Phantom Blocker
bloquea la alimentación Phantom, dejando intacta la señal de audio. La alimentación fantasma se puede aplicar ya sea al hombre o el lado hembra del conector XLR...

Más información

Bloqueador de alimentación Phantom

Phantom Blocker
bloquea la alimentación Phantom, dejando intacta la señal de audio. La alimentación fantasma se puede aplicar ya sea al hombre o el lado hembra del conector XLR de Phantom Blocker y no alcanzará el conector XLR opuesto, la señal de audio viaja sin restricción en ambas direcciones.

Applications:
Microphone preamps
Some (older) preamps are sensitive for Phantom power at the input. The preamp's input transformer cannot handle Phantom power from another source. The transformer's thin silk isolations can burn out because a burst of Phantom power switching on creates a high voltage in the input transformer ,to prevent this a complete blocking is needed.

Unbalanced TRS to XLR cables
When connecting an unbalanced TRS to XLR cable pin 3 of the XLR connector is directly connected to ground, creating a short, this can damage input transformers and under-dimensioned phantom power circuits.

Balanced device outputs
Phantom blocker is a great solution to protect the output of any device connected to the XLR input of a mixing desk or preamp which has Phantom power switched on, e.g. your computers audio interface.

Microphones
There are microphones (mainly Ribbon microphones) which do not tolerate Phantom power, to protect your Ribbon microphone against Phantom power we advise FetHead. Connecting a ribbon microphone to a cable which has Phantom power applied sends a rush of current through the microphones transformer, this current gets amplified by the transformer into the primary circuit of the microphone and forces the ribbon out of the magnetic field it is suspended in, this can permanently stretch the ribbon.

Important !
Before connecting the device you wish to shield from Phantom power make sure Phantom blocker is attached, have Phantom power switched on and wait 5 seconds during which Phantom blockers internal bleeder resistors will cancel out voltage differences. Connecting in this order prevents the transfer of an initial AC voltage burst created by the Phantom power switching on.

Características

·